Custom Cooling Fan Assembly for Chassis Dyno Application (Local Pickup only-Northern NJ) - in addition to the smaller "carpet fans" for spot cooling, this industrial grade portable fan assembly can be located in front of the vehicle to move large amounts of air through the radiators and to flush heat soaked air out of the room. My cost on this assembly (fan, electrical components and construction) was in excess of $2,000. This fan has been used very little and is no longer needed as the chassis dyno I had in the shop was sold years ago. Built to be stored under a workbench when not in use. See video.

You don't need a chassis dyno to put this fan to good use.......it'll move hot air, car exhaust and odors out of your shop very effectively.

• Continental AFK 270 (27") direct drive flange fan
• 5 Blade, GRP propeller, cast aluminum hub, adjustable pitch
• Steel housing with factory pain finish
• 1HP, 230v/1ph, TEFC, 1170 RPM motor
• Unit delivers 7500CFM @ 0.2" SP (most whole house fans are 3000-4500 cfm)
• Eaton Box 2 enclosure with eternal start/stop switch
• Includes blade guard
• Heavy duty SJTOW cable with Hubbell twistlock plug
• Low profile casters
• Measures 35" high by 29" deep by 34 1/2" wide...fits under a Lista 900 height (39") countertop
• Made in USA

Comments - I had custom side grills made for the assembly but they had to be removed as the unit was starving for air. With the top and sides open, the fan is capable of moving 7500CFM of air. Also, the rear of the assembly is typically set on a 3/4" thick pad (lifting the rear wheels off the ground) so the unit is not propelled backwards from the high flow of air.