Falcon Corrugated Stainless Steel Faucet Supply Hose (3/8 Compression x 3/8 Compression) - 48" - 7/16" Outside diameter with full port connections for maximum water flow. Safer alternative to braided hose. No plastic nuts or rubber tubing. 3/8" compression connections at both ends. Typically used with faucets with 3/8" OD tube pigtail connections and 3/8" connections at the shutoff valve. Available in 16", 26", 48" and 60" lengths. Typically purchased in pairs.

Falcon hoses will not discolor, corrode or rust nor will they crimp or kink. Other features include.......

• 304 Series Corrugated Stainless Steel
• Stronger and more flexible than copper
• Re-usable and Re-bendable
• Minimal deformity in Curvature...these hoses will hold a bend
• Burst pressure rated to 2200psi
• Re-Usable and Re-Bendable
• No Galvanic Effect (no dielectric union is needed)
• All fittings are chrome plated solid brass
• High temp EPDM Washer (-40° to 220 °F)
• 100% leak tested
• Falcon Warranty

Tools Required - The fittings on this hose can be tightened with an adjustable wrench or with an 11/16" (17mm) open end wrench.

Additional Comments - Stainless steel braided hoses marketed online and in the big box stores as superior alternative to rubber hoses and rigid metal pipes. These hoses consist of a flexible rubber inner tubing surrounded with a stainless steel metal braided sleeve. Some have metal nuts, others are plastic. There's a fair amount of discussion online, and a few horror stories, about inspecting and replacing braided hoses far more frequently than I had assumed necessary.