Falcon 3/4" ID Water Heater Connector - 3/4 x 18" - recommended for maximum water flow through 3/4" pipe. Great for most water heater and water softener connections. This hose is 3/4" ID with 3/4" FIP connectors ("Female Iron Pipe"....ie, Female NPT) on both ends. Available in 6 different lengths - 12", 15", 18", 24", 36" and 48".

Falcon hoses will not discolor, corrode or rust nor will they crimp or kink. Other features include.......

• 304 Series Corrugated Stainless Steel
• Full Port - no rubber or plastic hose or inserts to reduce flow
• Stronger and more flexible than copper
• Re-usable and Re-bendable
• Minimal deformity in Curvature...these hoses will hold a bend
• Burst pressure rated to 1850psi
• Re-Usable and Re-Bendable
• No Galvanic Effect (no dielectric union is needed)
• All fittings are chrome plated solid brass
• High temp EPDM Washer (-40° to 220 °F)
• 100% leak tested
• Falcon Warranty

** The fittings on the 3/4" FIP hoses can be tightened with an adjustable wrench or a 1 3/16" (30mm) open end wrench. Please do not use a pipe wrench. I personally like Facom's 70A series ratcheting flare wrench as this contacts the fitting on all 6 points and is less damaging to the chrome plating. This wrench retails for over $100 but is currently available at a 50+% savings.